Right LED marker lamp on short stalk with reversing sensor HOR 101 LDCC 2795 Horpol 12/24V

Marker lamp LDCC 2795, HOR 101, with reversing sensor module, right – Horpol

The Horpol LDCC 2795 marker lamp from the HOR 101 group on a short, straight stalk combines three light functions and a reversing sensor in one housing. Seven LEDs provide a white front marker light (6500 K), red rear marker light and amber side position light (2700 K). The ultrasonic sensor module is mounted at the rear corner of the vehicle, independently of the sensor on the other side.

The lamp signals active reversing mode by flashing from the moment reverse gear is engaged. The flashing frequency increases as the obstacle gets closer; when the obstacle is nearer than 80 cm, the light becomes steady. The sensor works only at low driving speed. Thanks to its approval, the lamp can be used legally on public roads, and the sensor also helps when reversing off-road, e.g. in manoeuvring yards and car parks. The driver must still take particular care – the device only assists them.

The supply voltage is 12/24 V and the round 3x0.5 mm² cable is 1.5 m long. The plastic housing has ingress protection IP68 and operates in the range from −30°C to +50°C. Mounting side: right.

Technical data

• Part number: LDCC 2795
• Lamp group: HOR 101
• Supply voltage: 12/24 V
• Rated power: 1/2.4 W
• Ingress protection: IP68
• Operating temperature range: from −30°C to +50°C
• Cable: 3x0.5 mm², round, length 1.5 m
• Mounting side: right
• Approval: E9*7R02/27*23093*00 (A-R1) + E9*91R00/17*23093*00 (SM1)
• Category: marker lamp with reversing sensor module
• Lamp type: LED, 7 LEDs in total
• Functions: front marker light (white, 6500 K), rear (red), side position (amber, 2700 K)
• Reversing sensor module: ultrasonic; below approx. 80 cm from an obstacle the indicator shows a steady light

Dimensions and fit

• Lamp head thickness: 37 mm
• Cable length: approx. 1500 mm (1.5 m)
• Mounting hole spacing: 78 mm
• Mounting: short, straight stalk
• Sensor module mounting plate: 46 x 116 mm
• Total assembly length (lamp + sensor module): 146 mm

The right LDCC 2795 marker lamp from the HOR 101 group with reversing sensor module is available at zemot.com.pl.